Tech – for Everyone

Tech Tips and Tricks & Advice – written in plain English.

What to do when your device gets wet

AKA “When your cellphone goes for a swim”

Folks, talking with a friend the other day, I was reminded of the fact that sometimes, despite our best efforts, we spill our drinks … and sometimes we do that right onto our expensive electronic gadgets. So I am reposting one of my very first Tech–for Everyone articles which tells the steps you should take to (maybe) rescue it in case of a spill.

From time to time I do something stupid — like  stub my toe or knock my coffee mug over or blurt out a blaspheme in the general vicinity of women and small children. On my better days, I sometimes do all three at once. This Saturday I went swimming, and I had my cell phone in the pocket of my shorts. Like I said, stupid. To my credit, I noticed that sad fact quite quickly. But the damage had been done. The phone had suffered not just a spill, but total immersion–submersion–and it was wet. In my defense…it was over a hundred degrees. In the shade.

It is a simple and a natural fact that electronic devices and water (or coffee) don’t ‘play well together’. It would not in the least be unreasonable to assume that Total Immersion of an electronic device (such as my phone) would render it, to use a technical term, kaput. Quick action on my part, good fortune, and the fact that I wasn’t using the phone underwater (it was “off”) combined, in this particular case, for a much happier result, and my phone seems to be no worse for its adventure. [The fact that my make and model phone is very low end probably, to my way of thinking, helped a bit too. It has always struck me that the more costly to replace something is, the more delicate and fragile it is. A cosmic law, perhaps?]

Tip of the day: Rescue your drowned device with quick action.
Should you be suddenly struck with a case of bad luck and/or fumble-fingers, and you spill your drink right onto your keyboard, or you find some other creative way to get liquid onto your digital device, all may not be lost. The quicker, and more effectively you do the following, the better your chances of saving your device from the recycler’s heap.

1) The first and most important thing is to turn it off and remove any power source. Shut it down, yank the cord, remove the battery, isolate the dilithium crystals! And do it fast. Some devices, such as those connected to your PC by USB cables, and keyboards, get some voltage through their connecting cable, so also remove any attached cords or cables. Turning it off is not enough. You need to open the cover and remove any batteries. Remember, it is not the moisture which will ruin your device, it’s “short circuits”, and those are an electrical phenomenon.

2) Get as much of the moisture out as quickly as possible. Pick it up and let gravity drain it as much as possible. You should have the battery cover off already, now open up the device as much as possible. If we’re talking about a laptop, remove any PCMCIA cards (PC cards), release and remove the optical drive, and turn it upside down and with a screwdriver remove any access panels — such as the one covering your RAM chips. If your model allows, release the spring-latches and remove the keypad.
If we’re talking about a cellphone or PDA or MP3 player, try “popping” its case with a flat-head screwdriver. If the Web is available on another nearby machine, go online and look at the manufacturer’s instructions for opening the device’s case. Now that it is opened as much as possible, gently blot with a paper towel, or whatever absorbent material is handy.

[Note: If the liquid you spilled is the kind that dries sticky, you have more work to do. If it’s available, use rubbing alcohol (the “purer” the better) and cotton swabs to clean it up as much as you can. If rubbing alcohol is not handy, use water. Yes, water. Distilled if possible.]

Removing the moisture is key: drain and blot what liquid you can see. When that’s done, rest assured that there is still more liquid lurking in your device. Now is when absorption and evaporation become our friend. Since it was a hundred degrees outside, I simply left my phone in the sun for several hours. If sunshine is not an option, you can try using a hairdryer set to low (this will take a while), or if you’re brave (and ready to stand and keep a close eye), place it in a conventional oven set no higher than 150 degrees (65°C), for an hour. In the case of a PDA or phone, you can also carry it, wrapped in tissue or a hanky, close to your body in a pocket. Another trick is to place the device in a sealed plastic bag with a handful of uncooked rice. Replace the rice every couple of hours or so.

3) Regardless of the method used, I strongly advise you to not reassemble and power up your device until the following day. Give evaporation/absorption every chance.

If you are lucky, and have lived a “clean life”, your device will power up and function just fine — good luck and how quickly you removed the power being the key contributors to your success. If, however, you power up and your device functions strangely, or not at all, you may be able to isolate and replace the malfunctioning component (if you’re an experienced troubleshooter type). Or you may want to take it in to your friendly neighborhood repair shop and have them do it. Sometimes it is more cost-effective to simply replace the device; your particular sitbetterSimpsonuation will vary.

Today’s free link: Friday Fun! Burger King has put up a flash-based website that let’s  you upload a picture, and it will convert it to what it would look like if drawn byThe Simpsons animators. I uploaded my portrait, and here’s how Tech Paul would look…
The site is

Today’s free download: As my faithful readers know, I am a big proponent of combating the modern plague of adware, spyware, and all sorts of malware. I have posted links for the better free versions of anti-spyware applications in the past. Sometimes though, it pays to invest in a “professional strength” application. The subscription-based anti-spyware application I use is the consistantly top-rated Webroot Spy Sweeper. I suggest you try-before-you-buy whenever possible, and to do that with Spy Sweeper, click here.

Copyright 2007-9 © Tech Paul. All rights reserved. post to jaanix

Share this post :

April 10, 2009 - Posted by | advice, gadgets, tech | , , , , , , , ,


  1. […] bookmarks tagged delicate What to do when your device gets wet saved by 1 others     mewKish bookmarked on 04/10/09 | […]


    Pingback by Pages tagged "delicate" | April 10, 2009 | Reply

  2. TechPaul,

    Great article… I may be pointing my readers to this article. Oh, another tip is disinfectant… Especially when that cellphone goes for a swim in the toilet! (LOL).



    Comment by whatsonmypc | April 10, 2009 | Reply

    • No joke. It happens. In that situation, I recommend fully immersing the device in purest rubbing alcohol.


      Comment by techpaul | April 10, 2009 | Reply

  3. […] good friend, Tech Paul, at “Tech-for Everyone” posted an article today that is important information on what to do when “electronics and water […]


    Pingback by What to do when your cell phone takes a swim… « What’s On My PC | April 10, 2009 | Reply

  4. […] good friend, Tech Paul, at “Tech-for Everyone” posted an article today that is important information on what to do when “electronics and liquids […]


    Pingback by eBliss >> What to do when your cell phone takes a swim… | Gadgets and Electronics reviews | April 11, 2009 | Reply

  5. I think you should clarify what degrees you are using for the oven advice. :) 150C seems too much.


    Comment by Rarst | April 12, 2009 | Reply

    • Rarst,
      I thank you, as you are quite correct. The point is not to bake the device, but to warm things enough for evaporation. Frankly, the oven is my least favored way.. personally I would use the rice-in-a-baggie trick, though it involves more work and takes longer.
      I will alter my article’s text.


      Comment by techpaul | April 12, 2009 | Reply

  6. I was ale to revive my Sony Ericsson W910i, just by switching off and Switching on after two days. This happened when my 3 years’ old daughter slipped it into the tub for about one and a half minute.


    Comment by desinet1 | April 13, 2009 | Reply

    • desinet1,
      Evaporation. It must have been warm where you were.

      I’m glad you had good luck.


      Comment by techpaul | April 13, 2009 | Reply

Post your Comment/Question

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

%d bloggers like this: